NEC Univerge SV8100 - Bluetooth Hub Adapter; Installing the BHA-L UNIT

Issue 4.1 UNIVERGE SV8100
5 - 88 Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
SECTION 8 BLUETOOTH HUB ADAPTER
8.1 Bluetooth Hub Adapter (BHA) Features
The BHA-L UNIT adapter connects a Bluetooth device to a multiline terminal.
The BHA-L UNIT cannot be connected to the DTL-2E-1 or DTL-6DE-1
telephone.
8.1.1 Installing the BHA-L UNIT
1. Turn multiline terminal upside down.
2. Unplug the line cord and handset cord from the multiline
terminal.
. Only one BHA-L UNIT can be attached to the DTL multiline terminal.
3. Lower the tilt leg to the first position (refer to Figure 5-110
Separate Tilt Leg from Leg Support).
4. Remove the connector cover (rubber) from the bottom of the
multiline terminal (see Figure 5-111 Removing the Connector
Cover on page 5-89).
Figure 5-110 Separate Tilt Leg from Leg Support
Before installing or removing the BHA-L UNIT,
remove the line cord and the AC adapter from the
outlet.
Stoppers
Tilt Leg