NEC Univerge SV8100 - Apply Power to the 9.5 Chassis; Install AC Power Cord 9.5 Chassis; Install Additional Blades 9.5 Chassis

UNIVERGE SV8100 Issue 4.1
System Hardware Manual 3 - 55
back side of the chassis to an electrical service ground (such as a cold
water pipe).
2.8.1 Install AC Power Cord 9.5” Chassis
Locate the supplied AC power cord and attach to the AC Inlet located
on the back of the chassis [refer to Figure 3-67 CHS2U GW Chassis
(Rear View)].
2.8.2 Install Additional Blades 9.5” Chassis
Refer to Chapter 5, 2.1 Installation and Safety Precautions on page
4-3.
2.8.3 Apply Power to the 9.5” Chassis
Refer to Chapter 5, 2.6 Powering Up the SV8100 on page 4-9
Figure 3-67 CHS2U GW Chassis (Rear View)