Issue 4.1 UNIVERGE SV8100
3 - 72 Installing the SV8100 Chassis
3.3 Installing the External Batteries 9.5” Chassis
An optional, CHSGW SMALL BATT BOX can be installed to provide external
battery power to the CHS2U GW chassis during a power failure. The short-
term battery box will power the system for approximately 10 minutes.
3.3.1 Battery Installation
1. On the battery box compartment, remove the two screws then
lift and set aside the top cover.
2. Remove the metal support bracket.
3. Insert the two short-term batteries.
4. Place the battery cable on top of the batteries and adjust to take
up the extra length. Allow enough length for the connections to be
made to the equipment.
Figure 3-93 Remove Top Cover of Battery Compartment
Figure 3-94 Installing the Batteries
To Next Page
Loading...
