NEC Univerge SV8100 - Removing or Installing the Tilt Legs on the Multiline Terminal; Remove Tilt Legs

UNIVERGE SV8100 Issue 4.1
System Hardware Manual 5 - 41
4.9 Removing or Installing the Tilt Legs on the Multiline Terminal
The Tilt Legs can be removed or installed on the DT300/DT700 Series
multiline terminal.
4.9.1 Remove Tilt Legs
1. Place the telephone on a flat surface (button side down).
2. Separate the Tilt Legs and place them flat against the
telephone. See Figure 5-38 Separating the Tilt Legs.
3. Push downward (two arrows) and slide downward (refer to
Figure 5-39 Attach Tilt Legs to DT300/DT700 Series Terminal.
Figure 5-38 Separating the Tilt Legs
Figure 5-39 Attach Tilt Legs to DT300/DT700 Series Terminal