NEC Univerge SV8100

To Next Page

To Previous Page

Issue 4.1 UNIVERGE SV8100

2 - 16 SV8100 System Specifications

SECTION 5 SYSTEM REQUIREMENTS AND SPECIFICATIONS

5.1 Cabling

This section provides cabling requirements and specifications for various

equipment used in the SV8100 system.

Figure 2-4 Connecting the DLC Using Twisted 2-Pair Cable is a diagram of the

chassis connected with each of the multiline terminals and single line

telephones by a separate twisted 1-pair cable or 2-pair cable (only for Multiline

Terminals).

Refer to the following tables for cabling requirements and specifications.

 Table 2-12 DT300 Series Loop Resistance and Cable Length

 Table 2-13 DT700 Series Loop Resistance and Cable Length

 Table 2-14 D

term

Series i or D

term

IP Terminal Loop Resistance and Cable

Length

 Table 2-15 Cable Connection Between the Analog Port and the Single Line

Equipment

 Table 2-16 Cabling Requirements

Figure 2-4 Connecting the DLC Using Twisted 2-Pair Cable

Table 2-12 DT300 Series Loop Resistance and Cable Length

Terminal or Adapter

By Twisted 1-Pair

Cable (without

AC Adapter)

24 AWG

By Twisted 1-Pair

Cable (with AC

Adapter)

24 AWG

DTL-2E-1 (BK) TEL