NEC Univerge SV8100 - Install Tilt Legs

Issue 4.1 UNIVERGE SV8100
5 - 42 Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
4. Lift and remove the Tilt Legs.
4.9.2 Install Tilt Legs
1. Place the telephone on a flat surface (button side down).
2. Lay the adjustable Tilt legs on top of the telephone. See Figure
5-40 Attach Tilt Legs to DT300/DT700 Series Terminal.
3. Push the Tilt Legs upward until they snap into place.
4. Lift both ends of Tilt Legs until they come together (refer to
Figure 5-41 Connecting the Tilt Legs on page 5-43).
Figure 5-40 Attach Tilt Legs to DT300/DT700 Series Terminal