NEC Univerge SV8100 - LED Indications; Switch Settings

Issue 4.1 UNIVERGE SV8100
4 - 22 Installing the SV8100 Blades
 Customer information is stored in the RAM memory and, in
case of a power failure, will be restored. The lithium battery in
the system saves the RAM memory when power is lost.
3.1.3 Switch Settings
Refer to Table 4-5 CD-CP00 Switch Settings for system restart/
system reset and with system power on. Figure 4-3 CD-CP00 Blade
Layout on page 4-16 shows the location of the SW1 switch on the
CD-CP00
blade.
3.1.4 LED Indications
The LEDs on the CPU indicate the following:
Table 4-5 CD-CP00 Switch Settings
USB Memory Status Operation
Switch
SW1 - Load
Switch
With a system restart or a system reset while holding the SW1
switch:
When USB Memory is not
installed:
Cold Start occurs.
When USB Memory is
installed:
USB Memory contents loaded.
When an unauthorized USB
device is installed:
System does not start and an “Illegal
USB device is connected” alarm is
recorded.
Table 4-6 CD-CP00 Switch 6 Settings
Configuration Note
SW6-1 ON Not Used
SW6-2 OFF Test Mode
ON = Test Mode
OFF = Normal
SW6-3 OFF RS232C Select
ON = Use
OFF = Not Used
SW6-4 ON Reset Configuration
ON = Normal
OFF = ICE Mode