NEC Univerge SV8100 - Flexible Call Routing

UNIVERGE SV8100 Issue 4.1
System Hardware Manual 4 - 23
 RUN (LED 1) = The CPU is operating (green)
 LED 2, and 3 = Alarms (red)
 LED 4 = Flash access indication (red)
 LED 5 = The USB memory connection status (red)
(LED off when no USB memory installed)
 Refer to Program 90-10: System Alarm Setup for details on assigning
alarm LEDs.
Table 4-7 CD-CP00 LED Indications on page 4-23 provides a list of
each LED and associated operation and status indications. Refer to
Figure 4-3 CD-CP00 Blade Layout on page 4-16 for the location of
the LEDs on the CD-CP00.
Table 4-7 CD-CP00 LED Indications
LED Indication
Status
RUN (LED1) LED2 LED3 LED4 LED5
Blinking Off Off Off On Steady When
USB Memory is
Installing
System operating normally
Off Off Off Off Blinking Boot is starting
Off On Off Off Off Initializing the disk or
formatting
Blinking Blinking Off Access
Blink
On Steady When
USB Memory is
Installing
Boot program is initializing in
the flash memory
Off On On Access
Blink
On Steady When
USB Memory is
Installing
Reading system software
Off On Off Access
Blink
On Steady When
USB Memory is
Installing
Upgrading system software
On Blinking Blinking Blinking On Steady When
USB Memory is
Installing
Finish formatting (SRAM,
Flash)
Blinking Off Off Off Off DRAM error
Blinking Off Off On On Steady When
USB Memory is
Installing
FPGA version error
Blinking Off On Off On Steady When
USB Memory is
Installing
SRAM error