UNIVERGE SV8100 Issue 4.1
System Hardware Manual 4 - 21
2. Refer to Figure 4-4 CD-CP00 Blade with Daughter Boards
Installed on page 4-17 to Install the PZ-VM21, PZ-ME50 and/or
PZ-32IPLA/PZ-64IPLA/PZ-128IPLA daughter board, if
required.
3. Ensure the power supply is OFF, then slide the CPU into the
CCPU slot in the Controlling Chassis.
4. If external Background Music (BGM) or Music on Hold (MOH)
is being installed, plug the cable into the CN8 or CN9 pin jack
connector on the CPU. The other end of the cable plugs into
the music source.
Refer to the PGD(2)-U10 ADP in the Chapter 6 Installing
SV8100 Optional Equipment section 2.1 Using a PGD(2)-U10
ADP on page 6-1 for details on connecting to a music source.
When the system software is upgraded, the flash memory is
updated with the new software version. Either the Hot or Cold
start-up method can be used or the system can be upgraded
using system software. Refer to 2.6.1 Performing a Cold Start
on page 4-9, 2.6.2 Performing a Hot Start on page 4-10, or 2.6.4
Performing a Software Upgrade on page 4-13.
Figure 4-5 CD-CP00 Battery Installation
To Next Page
Loading...
