UNIVERGE SV8100 Issue 4.1
System Hardware Manual 5 - 89
5. Insert the lower claws of the Bottom Unit (see Figure 5-112
Installing the BHA-L UNIT) into precut holes on the multiline
terminal.
6. Align connector on inside of BHA-L UNIT and push down until
unit snaps into place.
7. Set tilt legs to desired position.
8. Return the multiline terminal to the numbered keypad in the up
position.
9. Connect the Line cord and the AC adapter.
Figure 5-111 Removing the Connector Cover
Figure 5-112 Installing the BHA-L UNIT
To Next Page
Loading...
