Issue 4.1 UNIVERGE SV8100
3 - 38 Installing the SV8100 Chassis
3. With brackets snug against the 9.5” chassis, carefully slide the brackets
in opposite directions (refer to arrows Figure 3-43 Stand Mount Brackets
Installed), until they snap into place.
4. Secure the 9.5” assembly to a flat surface with the four screws supplied
(refer to Figure 3-44 Secure the 9.5” Stand Mounting with Screws on
page 3-39).
Figure 3-43 Stand Mount Brackets Installed
To prevent possible damage to the 9.5” chassis due to
falling, NEC recommends the screws be installed in
the stand mount brackets as soon as possible.
To Next Page
Loading...
