UNIVERGE SV8100 Issue 4.1
System Hardware Manual 3 - 67
9. Install batteries into Battery Tray. Refer to Figure 3-85
Connecting Battery Cables.
10. Using two screws, install the Battery Tray Bracket. Refer to
Figure 3-83 Removing Battery Tray Bracket on page 3-66.
11. Insert Battery Connection Cable into cable guides. Refer to
Figure 3-85 Connecting Battery Cables on page 3-67.
12. Install the Battery Tray Cover and tighten the two screws.
Refer to Figure 3-85 Connecting Battery Cables on page 3-67.
13. Slide the Battery Trays into the CHS LARGE BATT BOX.
14. Install the Battery Tray Suppressor while pulling the Battery
Connection Cable(s) through the cutouts provided. Refer to
Figure 3-86 Connecting Battery Cables on page 3-68. Secure
with two screws.
15. Plug the Battery Connection Cable(s) into the Fuse Unit. Refer
to Figure 3-86 Connecting Battery Cables on page 3-68.
Figure 3-85 Connecting Battery Cables
To Next Page
Loading...
