NEC Univerge SV8100 - Page 167

UNIVERGE SV8100 Issue 4.1
System Hardware Manual 4 - 19
 MF Signal Sender (Sends caller information to CO for E911)
 Call Progress Tone Detection
 C-Channel Control
 Conference: 64 Channels
 Caller ID Receiver; 32 Channels
 Caller ID Generator; 4 or 10 Channels for Analog Stations
 This can be expanded up to 20 by disabling 32 channels of the
Conference circuits and disabling the MFC Tone Sender
 A load switch which is used for initial system startup, resetting the
system, or when upgrading system software
 One Serial Port (null modem/cross-over cable required)
 One USB Port – USB 1.1/2.0 (requires USB driver – download from
NEC web site)
 One Gbit Ethernet Port for VoIP function
 One CompactFlash Card Slot
 Background Music/EXSP Control Port
 Status LED
 BGM LED
 EXSP Control LED
 Two Audio Input/Output Terminals
 One General Purpose Control Terminal
 One Music On Hold External Source
 HDLC Packet Processing
 Real Time Clock (tolerance 30 seconds/month)
 Internal MOH Generation (supplied from Melody IC)
 Call Control Server (ex: Conference Bridge Server, Voice Mail Server,
SIP Server, RTP Forwarding, VoCoder Conversion)
 One lithium battery (Sony CR2032 or equivalent) which provides
battery back-up of system data and RAM memory for approximately 30
months.
The CD-CP00 functions provided are:
 Call Control Server
 Conference Bridge Server
 Voice Mail Server (voice mail requires a compact flash card)
 SIP Server