Issue 4.1 UNIVERGE SV8100
5 - 50 Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
3. Pry the side panel from the multiline terminal.
4. Return the multiline terminal to the buttons side up
position.
5. Fit the projections on the side of the 8LK-L UNIT
into the guide holes on the side of the multiline
terminal.
6. Secure the 8LK-L UNIT with the two screws
provided.
7. Turn the multiline terminal upside down.
Figure 5-52 Remove Side Panel from Multiline Terminal
Figure 5-53 Securing the 8LK-L UNIT with Screws
To Next Page
Loading...
