Issue 4.1 UNIVERGE SV8100
5 - 80 Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
10. Insert the cradle connecting cable of the Bluetooth Cradle
(BTC) into the unit connector.
11. Fit the projections on the side of the Bluetooth Cradle into the
guide holes on the side of the terminal and pull toward you
(Figure 5-96 Attach Bluetooth Cradle to the Multiline Terminal)
until the unit snaps into place.
12. Attach the side panel to the Bluetooth Cradle.
13. Press the connecting cable into the grooved cutout.
Figure 5-96 Attach Bluetooth Cradle to the Multiline Terminal
Figure 5-97 Grooved Cutout for Connecting Cable
To Next Page
Loading...
