UNIVERGE SV8100 Issue 4.1
System Hardware Manual 6 - 47
10. Gently press the serial cable into the grooved cutout for the
cable.
11. Connect the serial connection cord (refer to Figure 6-39 Attach
PSA-L Unit to the Multiline Terminal on page 6-46) from the
PSA-L UNIT to the terminal body.
12. Open the Dip Switch Cover (refer to Figure 6-35 PSA-L UNIT
Connections on page 6-44). Set the dip switch on the PSA-L
adapter to the required position. Close the cover.
13. If using the handset, place the stopper in the tilt leg.
Figure 6-40 Grooved Cutout for Serial Cable
Figure 6-41 Insert Stopper for Handset Use
To Next Page
Loading...
