NEC Univerge SV8100 - Page 45

UNIVERGE SV8100 Issue 4.1
System Hardware Manual 2 - 9
Table 2-4 Maximum System Capacities – Blades shows the maximum number for
each blade that can be installed in a system.
This is determined by the maximum blade configuration allowed. When installing
single line sets, DISA, or tie lines, CPU circuits must be allocated for DTMF receivers.
To install single line sets with CO/PBX line access, or when installing immediate-start
tie lines, CPU circuits must be allocated for dial tone detection.
Table 2-4 Maximum System Capacities – Blades
Hardware
9.5”
Chassis
19”
Chassis
with CPU
19”
Chassis
without
CPU
19”
Chassis
x4
Comments
Number of Slot(s) for Interface
Package
3 Slots 5 Slots 6 Slots 23 Slots
Common Control Blades:
CD-CP00 1100 –
PZ-32IPLA
(32-port VoIP Daughter Board)
1101This unit provides 32
VOIP Gateway
channels
PZ-64IPLA
(64-port VoIP Daughter Board)
1101This unit provides 64
VOIP Gateway
channels
PZ-128IPLA
(128-port VoIP Daughter Board)
1101This unit provides 128
VOIP Gateway
channels
PZ-32IPLB
(32-port VoIP Daughter Board)
1101This unit provides 32
VOIP Gateway
channels
PZ-64IPLB
(64-port VoIP Daughter Board)
1101This unit provides 64
VOIP Gateway
channels
PZ-128IPLB
(128-port VoIP Daughter Board)
1101This unit provides 128
VOIP Gateway
channels
PZ-ME50
(Memory Expansion Board)
1100 –
PZ-VM21
(Voice Mail Daughter)
1100Does include modem
Station Blades:
CD-4DIOPB
(4 DID/OPX)
2 5 6 23 When installed as an
OPX blade