UNIVERGE SV8100 Issue 4.1
System Hardware Manual 3 - 21
4. Using supplied screws, secure the CHS2U STAND KIT to the
floor (refer to Figure 3-23 Install Additional CHS2U STAND KIT
(EXT) on page 3-21).
5. Connect the ground wire to all chassis. Refer to 2.7.5 Install
19” Chassis Grounding on page 3-52 for complete details on
grounding the system.
6. Refer to 2.7 Installing the 19” Chassis on page 3-39 to continue
installation of the chassis or, Chapter 5 paragraph 2.2
Installing an Extension or Trunk Blade on page 4-4 for
installation of blades.
Figure 3-23 Install Additional CHS2U STAND KIT (EXT)
To Next Page
Loading...
