2 Safety notes
Prior to initial operation, please carefully read the following instructions for the sake of both
your own safety and the printer operating safety. Always observe any warnings and
instructions directly attached to the device. Keep this manual available in order to be able to
check back at any time.
Disregarding this manual may cause
• electric shock,
• injury by being drawn into the transport belt or transport rollers,
• damage to the equipment.
Pos: 13 /Bedienungsanlei tungen/Geräte neu tral/2.1a_Ü2_Allge meine Sicherheitshi nweise_Handbuch @ 0\ mod_1249563586836_912. doc @ 2673 @ 2
2.1 General safety notes
Caution!
Please read these notes with care.
Keep this manual for future reference.
All notes and warnings found on the machine are to be followed.
Pos: 14 /Bedienungsanlei tungen/Geräte neu tral/2.1c_Allgemei ne Sicherheitshin weise_Aufstellen des Gerä tes @ 0\mod_124273682704 4_912.doc @ 1710 @
Setting up the
machine
A safe, level position is necessary, when installing the machine.
Injuries may be caused by tipping, rolling away or falling.
The machine is to be protected from moisture.
The machine is not suitable for outdoor use.
Pos: 15 /Bedienungsanlei tungen/Geräte neu tral/2.1e_Allgemei ne Sicherheitshin weise_Elektrische Gefahr en_ZWEIPOLIG @ 0\mod_1 242736827372_912.d oc @ 1718 @
Electrical
Hazards
The power cable must only be connected to a socket with protective
grounding contact! The protective effect must not be compromised by
the use of an extension cable without a protective grounding
conductor. All interruptions of the protective grounding conductor,
within or outside of the machine, are prohibited.
When fuse failure occurs, electrical machine parts can still carry
voltage.
When making the connection to the mains power, be aware of the
connection values on the rating plate.
Run the power cable in such a way, that no one can trip over it. Do
not place any objects on the power cable.
When the machine is not in use over a long period of time, it should
be disconnected from the power supply in order to avoid any damage
in the event of a voltage surge.
Protect the device from moisture. When moisture enters the machine,
there is a danger of electrical shock.
Never open the machine. For reasons of electrical safety, the machine
should only be opened by authorized service personnel.
Pos: 16 /Bedienungsanlei tungen/Geräte neu tral/2.1f_Allge meine Sicherheitshinw eise_Betriebssic herheit/Reinigung/S ervice @ 0\mod_12427368 27200_912.doc @ 1714 @
To Next Page
Loading...
