66 User Manual Version 3.1
PAPER SENSOR
Here you can adjust the behaviour of the paper sensor.
Option Note
On
The paper sensor (also Top of Form (TOF) sensor)
detects the front edge and the rear edge of the
material. In this setting the paper sensor is active
over the complete length of the material. The paper
length is controlled in this setting, so paper jams or
double feeds will be detected.
Off
The paper sensor detects the front edge of the
material. Then the paper sensor is set to inactive until
5 mm before the anticipated rear edge of the
material. This allows to process materials that have
e.g. a colourful surface or a hole (die cut) in them.
The paper length is controlled in this setting, so paper
jams or double feeds will be detected.
To properly use this setting, the
correct material size must be
set in the printer. Either sent by
the PC software or measured
manually.
If the material separation and
transport is not setup correctly,
turning off the paper sensor can
cause misprints.
Default: On
Pos: 61.75 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Druc ker/Ü2/Ü2_2700_DOS_MODE @ 0\ mod_1254832327765_912. doc @ 4361 @
DOS MODE
Pos: 61.76 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Druc ker/Ü3/Ü4/Ü3_2701_LI NE MODE_SHUTTLE HEAD ONLY @ 2\ mod_1278590834732_912.d oc @ 23943 @
LINE MODE
This feature is used to set a number of lines that separate one page (address) from the
next.
0 to 99
Default: 0
Pos: 61.77 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Druc ker/Ü3/Ü4/Ü3_2702_HEX TO ASCII @ 0\mod_1254915739923 _912.doc @ 5003 @
HEX TO ASCII
Conversion from HEX to ASCII.
If the conversion is switched on, the printer interprets the percentage sign “%“ as a non-
printable control character. The two characters following the % sign are interpreted as HEX
values, e.g. %0C = Form Feed.
off, on
Default: off
Pos: 61.78 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Druc ker/Ü3/Ü4/Ü3_2703_A UTO LINEFEED @ 0\mod_125491 5734173_912.doc @ 4975 @
To Next Page
Loading...
