Pos: 100.5 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Printer Dri ver & Cables to PC/TCP /IP (619) /7.X.X_Ü3_How to test the Ethe rnet connectivity_ ONLY_619 @ 3\mod_1296547073 221_912.doc @ 29844 @ 2
11.4 How to test the Ethernet connectivity
Using the „ping“ command in the Windows Command Prompt, is an easy way to test the
Ethernet connectivity of the printer. With this command you can test if the printer is
correctly recognized via the Ethernet connection. To test the Ethernet connectivity perform
the following steps.
1. Check the
IP address of
the printer
• To test the Ethernet connectivity of the printer you need the exact
IP address which the printer uses.
• To check the printer’s IP address got to the printer menu:
SERVICE > CONFIGURAT. INFO
• Note down the printer’s IP address.
2. Open the
Windows
command
prompt
• On your PC select START > All Programms > Accessories >
Command Prompt
• Or type “cmd” in the search box of the Windows Start menu.
• The Command prompt will open.
To Next Page
Loading...
