50 User Manual Version 3.1
ADJUSTMENTS
Pos: 61.24 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Druc ker/Ü3/Ü4/Ü3_1302_ADJ USTMENT GAP @ 0\mod_125483127 2021_912.doc @ 4329 @
ADJUSTMENT GAP
Pos: 61.25 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Druc ker/Ü3/Ü4/Ü4_130204_V ERT.CORRECTION @ 0\mod_1 254489912225_912.doc @ 4164 @
VERT. CORRECTION
To optimize seamlessly transitions between the print lines of the moving printhead, the
vertical offset can be calibrated. This adjustment becomes necessary if a gap or an
overlapping area between the print lines becomes visible. The adjustments can be carried
out in 0.17 mm (
1
/
150
“) increments.
Positive values enlarge the print line spacing (Æ leads to gaps), negative values reduce the
print line spacing (Æ leads to overlapping areas).
-5, -4, -3, -2, -1, 0, +1, +2, +3, +4, +5
Default: 0
Pos: 61.26 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Drucker /Ü3/Ü4/Ü3_1303_ADJ USTMENT STEPS @ 0\mod_1254483974277_ 912.doc @ 4053 @
To Next Page
Loading...
