TRANSPORT PARAM.
Pos: 61.54 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Drucker /Ü3/Ü4/Ü3_2201_PAPER SPEED_ Only_AS-700/710 @ 0\mod_12549 14049061_912.doc @ 4879 @
PAPER SPEED
This feature is used to set how fast the product is transported forward in the printer. Choose
a lower setting for very thick or very sensitive products.
30%, 40%, 50%, 60%, 70%, 80%, 90%, 100%
Default: 100%
Pos: 61.55 /Bedienungsan leitungen/Gerät e spezifisch/Dr ucker/Menüpunkte Druc ker/Menü_Drucker_Hin weis_Nicht "Lock"-bar @ 0\mod_1254823525 509_912.doc @ 4313 @
When using a software application that was designed to control this
feature (e. g. Flexmail, BulkMailer), this configuration will be
overwritten with the settings of the software.
In this case use the software options to configure the printer.
Pos: 61.56 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Drucker /Ü3/Ü4/Ü3_2207_SHUTTLE SPEED @ 0\ mod_1254914556034_ 912.doc @ 4951 @
SHUTTLE SPEED
This feature is used to set the speed of the cartridge carriage (shuttle). Choose a lower
shuttle speed setting, if a very precise alignment of the printed image is required. Note that
the speed of the shuttle determines the level of print quality you can set. See table below.
Option Possible print quality (dpi)
1315 mm/s 258.7 ft./min
1x3, 1x6, 2x3, 2x6
1052 mm/s 207.0 ft./min
1x3, 1x6, 2x3, 2x6, 3x3, 3x6
789 mm/s 155.2 ft./min
1x3, 1x6, 2x3, 2x6, 3x3, 3x6
526 mm/s 103.5 ft./min
1x3, 1x6, 2x3, 2x6, 3x3, 3x6, 6x3, 6x6
263 mm/s 51.7 ft./min
1x3, 1x6, 2x3, 2x6, 3x3, 3x6, 6x3, 6x6
Default: 1315 mm/s 258.7 ft./min
Pos: 61.57 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Druc ker/Menü_Drucker_Hin weis_Locking the SHUTTLE SPE ED @ 2\mod_1271144455684 _912.doc @ 14507 @
Locking the shuttle speed
Locking the shuttle speed is possible with firmware version 4.7 or
higher.
Pos: 61.58 /Bedienungsan leitungen/Gerät e spezifisch/Druc ker/Menüpunkte Druc ker/Ü3/Ü4/Ü3_2208_P RINTMODE @ 0\mod_125491455 5706_912.doc @ 4947 @
To Next Page
Loading...
