Neopost AS-710 - 5 Initial Start-Up of the Device; How to Power-On the Device

30 User Manual Version 3.1
5 Initial start-up of the device
Pos: 45 /Bedienungsanlei tungen/Geräte spezi fisch/Druc ker/5.0_print_fir st_test_page @ 1\mod_12633 02633152_912.doc @ 10181 @
This section describes all the necessary steps to print the first test page with your Neopost
AS-710.
Pos: 46 /Bedienungsanlei tungen/Geräte neu tral/5.2d_Ü2_How to po wer-on the device @ 0\mod_12508 56526091_912.doc @ 2869 @ 2
5.1 How to power-on the device
Pos: 47 /Bedienungsanlei tungen/Geräte spezi fisch/Druc ker/5.2d_Power-on the devic e_AS-700/710_ONLY_619 @ 3\mod_129905864912 5_912.doc @ 30636 @
Turn on the printer with the on/off switch located on the rear side of the device.
The printer will start an initialization and present the following messages (from top to
bottom):
Message Note
Loader -01
Version#2.0.xx#
Initialization of the monitor software. The version
number may differ.
STARTING APPLICATION
Version 4.8.xx –PPC
Initialization of the printer firmware. The version
number may differ.
Printer
Initialization
Initialization of the printer functions.
CHECK CARTRIDE
OK TO CONTINUE
CODE: 25
This notification is only shown when no cartridge is
inserted in the printer.
Proceed by pressing the Ok key. The printer will switch to the Online mode and the
display will show the main view.
Pos: 48 /Bedienungsanlei tungen/Geräte spezi fisch/Druc ker/5.1_Ü2_Installing the i nk cartridge _ EINE PATRO NE @ 1\mod_1261387725304_91 2.doc @ 10029 @ 2