QUICK MENU
The Quick key opens the following menu:
Pos: 61.3 /Bedienungsan leitungen/Geräte s pezifisch/Druc ker/Menüpunkte Drucker /Quick Menü/Ü2_6001_P RINTER RESET_FW_4.8 @ 3\ mod_1287746467437_912. doc @ 27909 @
PRINTER RESET
The PRINTER RESET process is used when a print job needs to be cancelled. This process
will clear the PC's spooler by first accepting all print data being sent from the PC application,
deleting them and then resetting the printer internal buffer.
To perform a PRINTER RESET execute the following steps:
• Select PRINTER RESET in the QUICK MENU and hit the Ok
key.
• CLEAR SPOOLER? Select and hit the Ok
key.
• Hit the Cancel
key.
• The orange Warning LED will blink until all print data is deleted from the spooler.
While deleting the data, the following information are shown in the display:
Data/s
Current transfer rate in bytes per second
o Data/s
Average transfer rate in bytes per second
Total Data
Total data transferred in bytes
Time [ms]
Total time elapsed in seconds
If your print job is large; pressing cancel from the software application
may shorten the time it takes to complete this task.
• When the orange Warning LED stops blinking; check whether your PC application has
sent all print data to the printer. For example check if the progress bar for this print
job reached 100%.
• When the software application shows that all print data has been sent or the job has
been cancelled, hit the Cancel
key on the printer.
• The printer will now clear the printer buffer and go back to the QUICK MENU.
Job cancel with PRINTER RESET
Performing a PRINTER RESET is a good way to securely cancel a
running print job. After performing a PRINTER RESET you can start
with a new print job.
Pos: 61.4 /Bedienungsan leitungen/Geräte s pezifisch/Druc ker/Menüpunkte Drucker /Quick Menü/Ü2_6002_C LEAR PRINT QUEUE @ 0\mod_125 4923958143_912.doc @ 5266 @
To Next Page
Loading...
