154 User Manual Version 3.1
6. Starting the
printer for the
first time after
the update
• If you were updating from a flashware version < 4.7 then perform
the steps below. If not continue with step “7. Checking the
flashware version”.
• Press and hold the Home
key and turn on the printer. This
will perform a default reset.
• Keeping holding the Home
key until the printer shows
Printer Name
Default Reset
• Use the Setting Dump, printed at the beginning of this process,
to set the previous mechanical alignment values.
7. Checking
the flashware
version
• Check the now installed flashware version in the printer menu:
SERVICE > CONFIGURAT. INFO > Firmware:
• Now the flashware update is completed.
IMPORTANT!
If an error message appears during the update process, just turn the
printer off and on. Check if you are sending a compatible Flashware
file. Try to resend the file.
Pos: 105 /Bedienungsanl eitungen/Geräte spe zifisch/Dr ucker/11_x_Ü2_Addition al information texts in main di splay_Table_Top_pr inters @ 2\mod_127 1235880723_912.doc @ 14712 @ 2
To Next Page
Loading...
