S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
Configure Switching User Manual163
Configure IGMP Snooping
You can configure the settings for IGMP snooping, which is used to build forwarding lists for
multicast traffic.
To configure IGMP snooping:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see
Discover or Change the Switch IP
Address on page 12.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is
password.
The System Information page displays.
5. Select Switching> Multicast > IGMP Snooping > Configuration.
6. Select the IGMP Snooping Status Enable or Disable radio button.
This specifies the administrative mode for IGMP snooping for the switch. The default is
Disable.
7. Select the Validate IGMP IP header Enable
or Disable radio button.
When IGMP IP header validation is enabled, any IGMP IP header must include the
Router Alert, T
oS, and TTL information. Otherwise, the IGMP packet is discarded. The
default value is Enable.
8. Click the Apply button.
Your settings are saved.
9. To refresh the page with the latest information about the switch, click the Refresh button.