S350 Series 24-Port (PoE+) and 48-Port Gigabit Ethernet Smart Managed Pro Switches
Specifications and Default Settings User Manual354
Switch Default Settings
The following table describes the switch default settings.
Table 73. Switch default settings
Feature Default
IP address 192.168.0.239
Subnet mask 255.255.255.0
Default gateway 192.168.0.254
Protocol DHCP
Management VLAN ID 1
Minimum password length Eight characters
SNTP client Enabled
Global logging Enabled
RAM logging Enabled (Severity level: info and above)
Persistent (FLASH) logging Disabled
DNS Enabled (No servers configured)
SNMP Traps Enabled
Auto Save Enabled
TACACS+ Not configured
RADIUS Not configured
Denial of service protection Disabled
Dot1x authentication
(IEEE 802.1X)
Disabled
MAC-based port security All ports are unlocked
Access control lists (ACL) None configured
Protected ports None
Advertised port speed Maximum capacity
Ingress storm control (broadcast, multicast,
and unknown unicast traf
fic)
Disabled
MAC table address aging 300 seconds (dynamic addresses)
Default VLAN ID 1