NSK EDD Megatorque Motor - Page 124

6. Operation
— 6-16 —
Line editing
 An example shown below describes changing the amount of rotation for present program to 45°.
1) The command CH (Editing channel) starts editing the program. The line with the inputted
program appears on the screen. Press the SP key to show the line to be edited.
:CH0
0>MV0.500;
1>ID9000;_
SP
0
?
H
C
ENT
2) Press the BS key to enter the editing mode of the line.
:CH0
0>MV0.500;
1>ID9000;
1?_
BS
The prompt “line number and ?” appears on the bottom line.
3) Input the new positioning command.
0>MV0.500;
1>ID9000;
1?ID4500
2?_
5
%
D
4
>
I
0
?
0
?
ENT
Completion of the input shows the next line with line number of 2.
4) Press the ENT key while the prompt “line number and ?” is on the bottom line.
1>ID9000;
1?ID4500
2?
:_
ENT
This completes the channel editing and the prompt “: (colon)” appears on the bottom line.
 Please use the channel editing screen when using the EDD MEGATERM.