NSK EDD Megatorque Motor - Page 126

6. Operation
— 6-18 —
Reading out of a program line
 When editing a program, you can read out a program line.
 Input ? + line number following the prompt “line number +?”. The program starting from the
specified line is repeated below. Press the SP key to scroll the next line.
 Other way of reading out a program line.
 An input of “?” following the prompt “line number +?” will repeat the program starting from
the current line.
 An input of “?S” following the prompt “line number +?” will repeat whole program starting the
top line.
0?MV0.500
1?ID4500
2??S
0>MV0.500;_
S
?
ENT
 An input of “?E” following the prompt “line number +?” jumps to the end line of the program
and the System waits for next input.
 Please use the channel editing screen when using the EDD MEGATERM.