NSK EDD Megatorque Motor - Page 127

6. Operation
— 6-19 —
Reading out of whole channel programs
 Though the command CH reads out contents of channel program, there is an exclusive command for
reading out channel program to prevent unexpected changes.
 Input the command TC (Tell channel program).
:TC/AL
>TC0;
0>MV0.500;
1>ID9000;_
ENT
C
/
T
L
A
It reads out the contents of the channel program.
 Press the SP key to scroll the next line.
 Press the BS to abort the readout.
Deletion of channel program
 You may delete all programs in a specified channel.
 An example below shows how to delete the contents of channel 10.
Input the command CC (Clear channel).
:CC10
:_
0
?
C
1
#
C
ENT