Enable Access control
Introduction
When you want to control access to your printer, you need to enable acces control in
Océ Express WebTools. With access control enabled, you are able to choose up to five
hosts who are allowed to communicate with the printer through your network. This
amount of hosts allows for a flexible configuration.
For each of the hosts you can decide whether the communication from this host to the
system needs to be encrypted by IPsec.
Note:
To enable access control or change the settings, you need to disable the 'Configuration'
– 'Connectivity' – 'Network adapter' - 'Enable DHCP' setting.
Note:
For this procedure, you need to log in as a System administrator.
Note:
Make sure to set a password for changing the network settings. With this password you
can reset the network settings from the user panel in case you get locked out of the system.
Set the password under the 'Configuration' - 'Connectivity' tab and edit the 'Password
to change network settings'. For more information, please refer to the connectivity
manual.
Enable 'Access control'
In Océ Express WebTools:
1.
Open the 'Configuration' - 'Connectivity' tab.
2.
Click on Edit in the upper right hand corner of the 'Access control' section.
3.
Change the 'Access control' setting from 'Disabled' to 'Enabled'.
4.
Click Ok to confirm.
Chapter 3 - Define your Workflow with Océ Express WebTools 129
Enable Access control
To Next Page
Loading...
Need help?
General
