Oce PlotWave 340 User Manual

Create an external location
Introduction
You can create an external location with Océ Express WebTools.
Before you begin
Note:
Make sure you enable 'SMB' protocol.
Note:
Make sure you enable 'FTP' under the 'Configuration' - 'Connectivity' tab.
Note:
Make sure the URL for 'WebDAV' and 'Eneo' is not blocked.
Note:
For this procedure, you need to log in as a System administrator.
Create an external location
1.
Select the 'Configuration' - 'External locations' tab.
2.
Click on 'Create new' in the upper right hand corner .
3.
Enter a 'Name' recognisable for the user. This name appears on the user panel.
4.
Enter a 'Description' description of the settings used.
5.
Select the 'Type' of the external location: 'FTP', 'SMB', 'WebDAV', or 'Eneo'.
Chapter 3 - Define your Workflow with Océ Express WebTools 153
Create an external location

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux