Oce PlotWave 340 User Manual

Move and re-adjust the printing system
Introduction
When you move the printing system to a new location, you must check if it needs re-
adjustment to ensure the best output quality.
You need two tools for the adjustment procedure. You can find these tools behind the
lower right front cover.
Required tool
•
Allen key
•
Key wrench
Attention:
When the printer is connected, you must first switch off and disconnect the printer (see
‘Switch off the printing system’ on page 280 and ‘Disconnect the network cable and the mains
supply cable’ on page 282).
Attention:
Close the media drawers.
Note:
Be aware of the size of the printer working area (see ‘Working area [Footprint]’ on page
25).
1.
Move the printing system to its new location.
Chapter 5 - Maintain the Printing System 283
Move and re-adjust the printing system

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux