Make a copy and remove a specific area of an original
Introduction
You can make a copy and delete a specific area of an original. You can use two settings:
'Area to erase: width' and 'Area to erase: length', to define the dimensions of the delete
area. And you can use two settings: 'Area to erase: X origin' and 'Area to erase: Y origin',
to define the relative position of the delete area on the sheet.
Before you begin
When you erase an area, make sure that you copy all the required information.
How to copy without a specific area of an original
1.
Feed the original face up and centred on the original feeding table.
Note:
You do not need to centre the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
The 'Copy' tile is automatically selected on the user panel.
2.
Tap the 'Copy' tile. A window with a list of presets opens.
3.
Tap 'All settings'. A list with settings opens.
4.
Tap 'Area to erase' under the 'Image' preset.
#
'Area to erase:
length'
'Area to erase:
width'
'Area to erase: Y
origin'
'Area to erase: X
origin'
5.
Select'Area to erase: X origin', 'Area to erase: Y origin', 'Area to erase: width', or 'Area to
erase: length' and define the values for your specific area.
6.
Make your settings and tap 'OK'.
7.
Define the number of copies and tap the green button.
Result
The printer copies an original without the specified area.
Chapter 4 - Use the Printing System242
Make a copy and remove a specific area of an original
To Next Page
Loading...
Need help?
General
