Oce PlotWave 340 User Manual

Set the 'Alignment' mode
Introduction
When you want shift the image on the sheet, you can change the alignment mode. With
the alignment mode you can also optimise the print productivity, as you reduce the dis-
tance the print carriage has to travel. You can, for instance, align the image to the top
right hand corner of the sheet.
You can choose the following alignment settings:
#
'Alignment' mode
'Top right''Top''Top left'
'Right''Centre''Left'
'Bottom right''Bottom''Bottom left'
Before you begin
For this procedure you need to log in as a Key operator.
How to set the alignment mode
In Océ Express WebTools:
1.
Open the 'Preferences' - 'Print job defaults' tab.
2.
Click 'Edit' in the 'Layout' section, or click on the 'Alignment' setting.
3.
Select the correct value.
Select 'Top right' when the print productivity is the most important factor.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools178
Set the 'Alignment' mode

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux