Oce PlotWave 340 User Manual

Set the Link speed and duplex mode
Introduction
Use Océ Express WebTools to set the transmission speed and duplex mode for your
network adapter.
Before you begin
Note:
For this procedure you need to log in as a Key operator.
Note:
The list of values you can select depends on the network card type.
Set the Network speed and duplex mode
In Océ Express WebTools:
1.
Open the 'Configuration' - 'Connectivity' tab.
2.
Click 'Edit' in the 'Network adapter' section, or click on the 'Link speed and duplex
mode' setting.
3.
Select the correct value. 'Automatic detection' is default. When automatic detection fails,
you must select the value that matches the properties of your local network.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools 179
Set the Link speed and duplex mode

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux