Oce PlotWave 340 User Manual

Make a copy and add a strip
Introduction
When you make a copy, you can add a strip to a document.
Use 'Sheet size' to copy an original without a strip, and add a strip to the copy. You can
add a strip at the top or bottom of a copy.
Note:
For more information on the cut size settings, see ‘Preset category:Layout ’ on page 227.
Illustration
How to make a copy and add a strip
1.
Feed the original face up and centred on the original feeding table.
Note:
You do not need to centre the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
The 'Copy' tile is automatically selected on the user panel.
2.
Tap the 'Copy' tile. A window with a list of presets opens.
3.
Tap 'All settings'. A list with settings opens.
Chapter 4 - Use the Printing System236
Make a copy and add a strip

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux