Oce PlotWave 340 User Manual

Configure the Automatic wake-up
Introduction
You can use Automatic wake-up to start up the printer automatically on each working
day. The wake-up time and working days are configurable.
How to configure the Automatic wake-up
1.
Open the 'Preferences' - 'System properties' tab.
2.
Click on 'Edit' in the 'Printer properties' section, or click on the 'Automatic on' setting.
3.
When you enable the setting, you must also enter the following settings in the 'Printer
properties' section: 'Start-up time', 'End of working day time', 'First working day' and
'Last working day'.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools 159
Configure the Automatic wake-up

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux