Oce PlotWave 340 User Manual

Do a default copy job
Introduction
When you want to copy an original and you do not make any settings the default presets
are used. You only use the Smart Access to submit your job.
You can see the presets that are used in the job settings section of your job.
Illustration
Do a default copy job
1.
Feed the original face up and centred on the original feeding table.
Note:
You do not need to centre the original precisely. The exact position of the original is au-
tomatically detected by the scanner.
Chapter 4 - Use the Printing System 221
Do a default copy job

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux