Oce PlotWave 340 User Manual

Set the 'Long plot mode'
Introduction
When the 'Long plot mode' setting is enabled, it allows you to print plots up to eight
times longer than when the setting is disabled.
For the printer to be able to print long prints, the print quality can be reduced.
Note:
For this procedure you need to log in as a Key operator.
Note:
The 'Long plot mode' setting does not apply for PDF or PostScript files.
How to set the 'Long plot mode'
In Océ Express WebTools:
1.
Open the 'Preferences' - 'Print job defaults' tab.
2.
Click 'Edit' in the 'General (non-postscript) rasterisation settings' section, or click on the
'Long plot mode' setting.
3.
Select the correct value. The setting is enabled when you check the box.
4.
Click 'Ok' to confirm, or 'Cancel' to reject your entries.
Chapter 3 - Define your Workflow with Océ Express WebTools174
Set the 'Long plot mode'

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux