Set the copy job default settings
Definition
In Océ Express WebTools you can configure the default values for the copy job settings.
When you optimise the copy job default settings for your document, you get the best
results.
The copy job settings are grouped under the 'Preferences' - 'Copy job defaults' tab. You
can find a short explanation of the 'General copy job settings' below.
Note:
Under the 'Preferences' - 'Copy job defaults' tab, you can also make settings for the copy
presets. Only the settings you make for the presets are visible on the multi-touch user
panel, under the 'Copy' tile. For more information on the copy presets, see ‘Set the copy
presets’ on page 141.
Overview of the 'Copy job defaults' - 'General copy job settings'
Note:
For this procedure, you need to log in as a Key operator.
Open the 'Preferences' - 'Copy job defaults' settings tab. Click edit in the upper right
hand corner of the 'General copy job settings'.
#
DescriptionSetting
•
Select 'Standard' for default speed.
•
Select 'Productive' for optimised speed: narrow originals
are scanned faster.
'Productivity mode for
copy ('Lines/text' only)'
•
Select 'Next larger', to continue printing with a larger
size media.
•
Select 'Exact size', to only continue printing when the
specified media size is available.
'Media selection policy'
Chapter 3 - Define your Workflow with Océ Express WebTools104
Set the copy job default settings
To Next Page
Loading...
Need help?
General
