Oce PlotWave 340 User Manual

You must wait approximately 15 minutes for the files to upload. The progress bar, at the
bottom of the page, indicates the progress.
3.
When the upload is finished, click 'Ok'. A dialogue window appears.
4.
To start the installation click on'Ok'. When you do this, a warning message is displayed.
The user panel now displays the message 'Do not switch off the system.', 'The system is
installing the software.', 'This may take a while.'.
When the software update is finished, the warning message disappears.
Attention:
You must wait for approximately 15 minutes. Do not touch anything while the installation
is taking place.
5.
Click 'Ok'' to return to Océ Express WebTools.
Result
Your software update is finished.
Note:
There is no specific user feedback on the result of the software update. Please check the
current software version of your system in the 'Support' - 'Update' tab.
Chapter 5 - Maintain the Printing System 279
Update the system software

Oce PlotWave 340 Specifications

General

Print Resolution	600 x 1200 dpi
Maximum Roll Width	36 inches
Memory	2 GB
Hard Drive	500 GB
Maximum Print Length	Unlimited
Maximum Print Width	36 inches
Media Handling	Roll feed
Connectivity	Ethernet 10/100/1000Base-T
Media Width	297 - 914 mm
Media Types	Recycled
Media Thickness	0.07 - 0.3 mm
Operating Systems Supported	Windows, Linux