Oce TCS500 - Use Océ Remote Logic for Remote Control

114 Chapter 4 Use the PLC applications to control your workflow
Introduction to Océ Remote Logic®
Use Océ Remote Logic
®
to control your
workflow from a remote workstation
Introduction to Océ Remote Logic®
The applications of Océ Remote Logic®
You must use Océ Remote Logic
®
to connect to the Océ Power Logic
®
controller
applications if you do not have a keyboard, mouse and monitor with your Océ Power
Logic
®
controller.
You can use Océ Remote Logic
®
to run the following applications from a remote
workstation.
■ Océ Settings Editor
Use the application to change the default settings of the system.
■ Océ Queue Manager
Use the application to manage the print jobs.
■ Océ System Control Panel
Use the application to view the status of the printer, the scanner and the
controller. You can also view the media available on the printer and the amount
of set memory in use.
User modes
The Océ Remote Logic
®
controller applications have different user modes (see ‘The
Océ TCS500 users’ on page 19). An additional user mode is the 'Service operator'
mode. This mode is for the Océ technician only.