Oce TCS500 - Connect to the Controller

120 Chapter 4 Use the PLC applications to control your workflow
Connect to the controller
Connect to the controller
Introduction
After you start one of the Océ Remote Logic
®
applications, you must connect to the
Océ Power Logic
®
controller of the Océ TCS500. You must connect to the system
for every separate application.
You can do the following when you connect to the controller.
■ Select a system from the drop-down list.
■ Add a system to the drop-down list.
■ Remove a system from the drop-down list.
When the Océ TCS500 is not available in the 'Connect to' dialog box, you must add
the Océ TCS500 to the list of available systems.
How to connect to a system
1. Open the application you want to run.
2. From the 'File' menu, select 'Connect to'.
3. Select the system from the drop-down list.
4. Click 'OK'.
Note: From the 'File' menu, select 'Options' to define the default system. This is
recommended if you frequently connect to the same system.
How to add a system
1. From the 'File' menu, select 'Connect to'.
2. Click 'Edit'.
The 'Edit systems' dialog box appears.
3. Enter the IP address or the name of the system in the 'System' box.
4. Click 'Add'.
The system is added to the list.
5. Click 'OK' 2 times to return to the application.
How to remove a system
1. From the 'File' menu, select 'Connect to'.
2. Click 'Edit'.
The 'Edit systems' dialog box appears.
3. Select the system you want to remove.
4. Click 'Remove'.
The system is removed from the list.
5. Click 'OK' 2 times to return to the application.