Oce TCS500 - Start Applications with Océ Remote Logic

117
Start the applications with Océ Remote Logic®
Start the applications with Océ Remote Logic®
Introduction
Use the following 2 methods to start the applications with Océ Remote Logic
®
.
■ Use the programs menu of your operating system.
■ Use a command line parameter.
Use the programs menu to start the applications
1. Select 'Océ Remote Logic'
2. Select the 'Launcher' application.
3. Select the required application.
The application starts with your default system.
Note: You can select another system than your default system (see ‘Connect to the
controller’ on page 120).
Use command line parameters to start the applications
Six command line parameters are available to facilitate the start of the applications.
■ configfile=<config_file>
Sets the configuration file to use.
■ server=server
Sets the indicated server as the server to connect to.
■ language1=lang
Specifies the first language in combination with the parameter
country1=country.
■ country1=country
Specifies the first language in combination with the parameter
language1=language.
■ language2=lang
Specifies the second language in combination with the parameter
country2=country.
■ country2=country
Specifies the second language in combination with the parameter
language2=language.
Note: Always use a matching combination of language and country (see the
following table).