60 Chapter 3 Prepare the Océ TCS500 for use
The sleep mode timer
The sleep mode timer
Introduction
The Océ TCS500 printer has 2 modes to prevent unnecessary power consumption.
■ The energy save mode.
■ The sleep mode.
This section describes the sleep mode.
The sleep mode
The Océ TCS500 printer uses less energy in the sleep mode than in the normal
operating mode and even less energy than in the energy save mode.
The power supply of the printer is turned off in the sleep mode. The Océ Power
Logic
®
controller remains turned on.
You can define the following sleep mode settings in the Océ Setting Editor.
[24]
Note: By default, the 'Sleep mode timer' is enabled and the 'Sleep mode time-out' is
set to 30 minutes.
If you must change the default settings in the Océ Settings Editor proceed as follows.
[24] Sleep mode settings in the Océ Setting Editor
Key Operator - Printer - Settings -
Timers - Sleep mode timer enable -
Sleep mode timer
Key Operator - Printer - Settings -
Timers - Sleep mode time-out
Enabled Use this setting to define the delay in
minutes before the Océ TCS500 printer
enters the sleep mode.
Disabled Not applicable
To Next Page
Loading...
