176 Chapter 7 Use the Océ TCS500 for copy jobs
Make multiple sets of copies
Make multiple sets of copies
Introduction
You can use the 'Create set' option to make multiple sets of copies.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the Océ Settings Editor.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the printer queue of
the Océ Queue Manager, a scan-to-file job appears in the selected destination of the
Océ Scan Manager.
Illustration
[149]
[149] The 'By set' (left) and 'By page' icon of the 'Collate' setting.
How to make multiple sets of copies sorted by set
1. Feed the first original face down and right aligned.
The scanner takes the original.
2. Define the job settings.
■ Select 'Copy' with the upper-left softkey.
The copy job templates appear.
■ Open a copy job template with a left softkey.
The 'Create set' option appears at the upper-right corner of the screen.
■ Select 'Create set' with the upper-right softkey.
The 'Cancel set' option appears at the upper-left corner of the screen. The 'Close
set' option appears at the upper-right corner of the screen.
■ Scroll to 'Collate' and define 'By set' with the left softkey. This setting is disabled
after you press the green start key for the first time.
■ Scroll to another setting if necessary, select the setting with the left softkey and
define the value with the scroll wheel.
■ Define the number of copies and press the green start key.
You cannot change the number of copies after you press the green start key for
the first time.
■ Feed the next original, define the enabled settings for this original if necessary
and press the green start key.
Repeat this step until all originals are fed.
3. Select 'Close set' with the upper-right softkey.
To Next Page
Loading...
