Oce TCS500 - What to Know Before Sending Print Jobs

144 Chapter 6 Use the Océ TCS500 for print jobs
What you need to know before you send your print jobs
Send print jobs to the Océ TCS500
What you need to know before you send your print jobs
Definition
Before you send print jobs to the Océ TCS500, remember the following.
■ The values defined in the Océ Settings Editor are default values for the system
(see ‘The user interface of the Océ Settings Editor’ on page 75). You can define
a number of job settings in the printer drivers or the job submission tools. The
settings defined in the printer drivers or the job submission tools always overrule
the settings defined in the Océ Settings Editor.
■ Make sure that you define the correct quality mode for your job
(see ‘The quality modes’ on page 187).
■ Make sure that you define the correct media type for your job
(see ‘Recommended media types and quality modes’ on page 189).
■ Make sure that you define the correct job settings. For example, orientation,
rotate, and media type.
Note: When the requested media type is not available on the printer, the printer will
give a media request. The job is then placed on hold in the print queue. After the
correct media is loaded on the printer and after you 'Resume' the job, the job will be
printed. When the job is placed on hold in the print queue, you can also select
another media roll for your job, with the option 'Settings''Job properties' in the Océ
Queue Manager.
A job submission tool like Océ Print Exec
®
Workgroup, provides you with
information about the media defined on the system. The printer drivers do not give
this type of information. When you use the printer drivers to send your jobs, use Océ
Remote Logic to view information about the media defined on the printer in the Océ
System Control Panel.