Oce TCS500 - Define Media Sizes

85
Define the media sizes
Define the media sizes
Introduction
Use this setting to define the default media range.
If you want to select a new media size on the operator panel of the printer, only the
sizes in the defined media series are available.
When 'Auto format' is enabled, the 'Media sizes' setting selects which sizes are used
(only those available in the 'Media sizes').
Before you begin
Open the Océ Settings Editor and log on as Key Operator. Take the following steps
to log on.
1. Click 'File' and select 'Log on'.
2. Select 'Key Operator' and enter the password.
How to define the media series
1. Click 'View' and select 'Key Operator settings'.
2. Navigate to Key Operator - System - Media - Media sizes.
3. Define the required value.
[31]
4. Click 'Apply' to confirm the settings.
5. Click 'File' and select 'Log off' to prevent unauthorized use.
Setting Group Values
'Media sizes' 'DIN' A, B, C, D, E, E+, 28x39"_707,
28x20"_707
'DIN carto' A, B, C, D, E, E+, 28x39"_700,
28x20"_700
'ANSI small' A, B, C, D, E, E+, 30 inch
'ANSI mixed' A, A+, B, B+, C, C+, D, D+, E, E+,
30 inch